Traknova
Dash Cam Troubleshooting: Find Your Fault by Symptom and Fix It Fast

Dash Cam Troubleshooting: Find Your Fault by Symptom and Fix It Fast

Sheriff Subair

The camera was supposed to be recording. It wasn’t, and you found out after the incident, not before. That is the worst version of a dash cam fault, which is why this dash cam troubleshooting guide starts with your symptom, not with a lecture on how cameras work.

Nearly every fault comes down to power, storage or connection, and each has a short list of checks. If you run a fleet, ask one more question before you replace any hardware: is this one camera, or the same fault across several vehicles? The answer changes the fix.

This guide is written for taxi, PCO, rental and dealership operators, though a single driver will find their fault here too. Brand steps differ, so where a fix depends on your camera’s maker, the linked guide says so.

Quick diagnosis: symptom, likely cause, where to fix it

SymptomLikely causeFull fix
Won’t turn onPower or SD cardNot turning on
Keeps turning offCable, adapter or SD cardKeeps turning off
Won’t chargeCable, adapter or power sourceWon’t charge
Car battery goes flatParking mode or kit setupDraining the battery
Cuts out on hot daysHeat protectionOverheating
SD card errorWorn or faulty cardCard error
Not saving footageCard, locked files or loop recordingNot saving
Footage overwrittenLoop recording doing its jobOverwriting
Footage won’t playDamaged file or cardCorrupted footage
Won’t join the appPhone and camera Wi-FiApp connection
4G camera offlineSIM or network settings4G not connecting
Wrong date or timeGPS time or settingsDate and time
On but not recordingUsually the SD cardNot recording
Rear camera deadUsually the cableRear camera
Stuck on boot screenCard, cable or accessoryBoot loop
DAB radio dropping outAdapter or cable positionRadio interference
Pink or purple at nightInfrared systemNight footage

Power faults: not turning on, turning off, not charging, battery drain and overheating

Check the supply before you blame the camera. A dash cam that won’t start or keeps cutting out is usually a problem with the socket, cable, adapter, hardwire kit or a fuse, and only then the unit. Reseat the cable at both ends, try a different cable and adapter, and stop using any connector that looks melted or discoloured. If the camera behaves with the SD card removed, the card is your next suspect.

Hardwired cameras add their own failures. A kit wired to the wrong feed will not start, for instance when it is tapped into a switched circuit where a constant one was meant, or onto the wrong side of the fuse slot. Which fuse and feed suit a vehicle is a job for an installer, not a forum thread. See the hardwire kit guide.

Flat batteries are the worry for rental cars and forecourt stock that sit for days. Parking mode and the kit’s cut-off settings decide whether the battery drains, and the cause is often a setup problem, not the camera. Start with parking mode battery drain, or the guide to a car battery draining.

On hot days, a camera that cuts out is protecting itself, not failing: see overheating in hot weather, won’t charge and keeps turning off.

A camera with clean power can still save nothing, and that is a storage fault.

Storage faults: SD card errors, not saving, overwriting and corrupted footage

When a camera seems to record but nothing is saved, suspect the SD card first. Loop recording writes to the card constantly and flash memory wears out. One UK retailer’s 2026 guide says most dash cam failures are the card, not the camera. A card that goes read-only, fails to format or keeps throwing errors needs replacing, and one maker’s forum advises replacing at the first error, or every one to two years of busy use. Back up anything you need before you format. See SD card error and card won’t read.

Locked clips are the other trap. When the camera protects a clip after a bump, that file is not overwritten, and enough of them can fill the card until normal footage stops saving. The G-sensor is the bump sensor that triggers the lock. See not saving footage and footage overwritten.

Use the card type your camera maker recommends. One maker says its cameras are sensitive to card quality and does not recommend a popular high-endurance brand, so a card that works in one make can fail in another. Buy the wrong card for a fleet and you repeat the fault on every camera. See the SD card guide.

Format at least once a month. Nextbase says every two to three weeks, so check your own maker’s guidance and go sooner if it says to. Owners report anything from every one to three weeks to every few months, which is why monthly is the floor, not the target: how often to format. Footage that won’t play at all is a corrupted footage problem. Footage that plays with the wrong time on it is a connection fault, and that is next.

Connection faults: app, 4G, live footage, date and time, and GPS

A 4G camera that stays offline after a SIM goes in most often needs the right APN, which is the network setting that tells the camera how to use that SIM, entered by hand, and the SIM checked as seated. Maker and supplier guides both start with the APN. See 4G not connecting and live footage not loading.

App faults are mostly on the phone side. The phone keeps auto-joining another network, an app permission is off, or it shows a no-internet warning. The camera’s own Wi-Fi only reaches a short way and only while the camera is on, so stand next to the vehicle with it powered. See won’t connect to the app.

Date and time errors matter more than they look. Some cameras take their time from GPS and override what you set. One owner reports no daylight saving option, so the clock can be wrong for part of the year. In a passenger dispute or an insurance claim, a wrong timestamp makes good footage harder to use. Updating firmware and resetting the GPS sync are the usual first fixes: wrong date and time and GPS not working.

If the camera is online, powered and saving, the next faults are the ones that look like a camera problem and are not.

Recording and hardware faults: boot loops, beeping, rear cameras, interference and night footage

Boot loops and beeping are found by elimination. Start the camera with the front unit only: if it boots, the fault is in the rear camera, its cable or an accessory. If it still loops, try another 12V cable, remove the SD card and test, unplug anything attached, then update firmware, and factory reset last. One maker’s support steps run in that order. See stuck on boot screen and beeping.

On dual cameras, a dead rear camera is almost always the cable, not the camera: rear camera not working. A camera that is on but not recording is nearly always the SD card: not recording.

Radio interference is usually a fitting problem. One forum owner found their DAB radio stopped working after a camera went in and wished they had known beforehand. A vendor guide puts it down to the rear camera cable running near the aerial, and one forum thread blames the power adapter. Neither points to a faulty camera: DAB interference.

Interior cameras in taxis and private hire cars that turn pink or purple at night usually have an infrared problem: night footage. That covers the faults. The routine below is what to run first on any of them.

The five dash cam troubleshooting checks to run first

Run these in order on any camera, before you buy a replacement:

  1. Power. Reseat the cable at both ends and try a different cable and adapter.
  2. Card. Remove it, back up what you need, reseat it, and replace it if it shows errors.
  3. Format. Format in the camera at least once a month, or sooner if your maker says so.
  4. Firmware. Install only the file your maker lists for your exact model, and test one camera before updating the rest.
  5. Reset. Factory reset last, because it returns every setting to default.

Record a short test clip after each change. If the camera records and plays back, you have your fix. If it does not, move to the next check.

These checks fix a single camera. They tell you nothing about the camera in the next vehicle.

One camera or the whole fleet? How to tell

One camera failing is a camera problem. The same fault on several vehicles is a fleet problem, and it has a shared cause: a batch of SD cards, a hardwire kit fitted the same way on every vehicle, a setting or firmware update pushed to all of them, or a SIM or network setting that was wrong from the start. Replacing the cameras fixes none of those. The fix follows the cause: replace the whole batch of cards, refit the kits, or correct the setting on every camera.

Three questions sort it out. How many cameras show the same symptom? What do they share, such as card batch, fitting date, installer, SIM provider or firmware version? And does the fault follow the part? Swap a card or cable from a working camera into a faulty one. If the fault moves with it, that part is the problem. If it stays, look at the camera or the fitting.

The harder risk is the camera that stopped recording weeks ago and nobody noticed. On a fleet of 30, the person who finds out is the one asking for footage after an incident. Pull a clip from every camera on a regular schedule, and treat a camera with no recent footage as a fault, not a quiet week.

When to repair, replace or call an installer

Whether to repair or replace depends on the fault pattern and the warranty. One camera failing after a clean fitting is a warranty or replacement question, and makers set their own repair and replacement terms, so check yours before you spend anything. The same fault across a batch points to a shared cause such as the fitting, the kit or a batch of cards, and the fitting and the kit are an installer’s job.

Stop and have the installation checked if warning lights, blown fuses or odd electrical behaviour appear after a camera goes in. A larger fuse hides a fault, it does not fix it.

Many owners wire in their own camera from forum advice, and for one car that can work. A fleet needs the same fitting on every vehicle, because one wiring mistake repeated across 30 cars is the batch problem described above.

If you run taxis or private hire cars in London and fit a camera, it must be on TfL’s approved list, so check any replacement against the TfL approved dash cam FAQ. The harder question is how you find out about a dead camera before you need the footage.

How Traknova helps fleets keep every camera recording

Pulling a clip from every camera is a job nobody owns once you pass a few vehicles. Traknova sells 4G dash cams, GPS tracking and immobilisers on one platform, so footage, location and vehicle information sit in one place instead of three. For the cameras it supplies, the platform shows whether each one is recording and flags any that have stopped, so you hear about it from the platform, not from a missing clip after an incident.

Running more than a handful of cameras? See how Traknova helps you spot a camera that has stopped recording before you need the footage. Book a free consultation.

Frequently asked questions

Why does my dash cam keep turning off? The power cable or adapter is the most common cause, so reseat both ends and swap the cable first. If it carries on, test with the SD card removed. See keeps turning off.

How often should I format my dash cam SD card? At least once a month. Nextbase says every two to three weeks, so follow your camera maker if it says sooner. See how often to format.

Why is my dash cam on but not recording? Most often the SD card. Reseat it, format it in the camera, and check loop recording is switched on. See not recording.

What does a memory card error mean? The camera cannot read or write to the card. Back up anything you need, then format it in the camera. If it still fails, replace the card. See SD card error.

Why won’t my 4G dash cam connect? Check the SIM is seated and that the camera has the right APN for the SIM’s network. See 4G not connecting.

Pull a clip from each of your cameras this week. If several have gone quiet, that is a fleet problem, and a conversation is worth having at traknova.com/contact.

Ask AI about TraknovaChatGPTClaudePerplexityGemini

Copyright 2026 Traknova Ltd. All rights reserved.